|
|
Post by Loon on Dec 1, 2004 5:55:02 GMT 8
Hey! I was planning to flash my Aladdin XT 4064, but i can't get the chip into "flashmode". I tried holding powerbutton for 5 sec (maybe more), but no flashing LEDs  and no success trying to flash either.. It just boots into the preflashed bios (vanilla EvoX). Is there a way to force it into flashmode? Thanx! |
|
|
|
Post by Mechaman on Dec 1, 2004 21:03:26 GMT 8
Hi, 1st thing to take note, if your set is v1.6 then the only Bios you can use is the EvoxM6_1.6, if you flash with Xecuter or other bioes that cannot support the v1.6 board then that's it your modchip will not boot  Flash your modchip with Eurasia Pro Generic Flash disk, u can find from www.xbins.org, download and see the instructions on how to create the disks For the XT just boot up the chip in normal mode, u would be able to flash it this way, no need to press and hold for more than 5s hope this helps rdgs mechaman Hey! I was planning to flash my Aladdin XT 4064, but i can't get the chip into "flashmode". I tried holding powerbutton for 5 sec (maybe more), but no flashing LEDs and no success trying to flash either.. It just boots into the preflashed bios (vanilla EvoX). Is there a way to force it into flashmode? Thanx! |
|
|
|
Post by Loon on Dec 3, 2004 18:50:48 GMT 8
The xbox is a v1.4, but thanx for the notice..
I'm just wondering, do i need to include the raincoat.cfg when flashing this chip? (It's a SST49LF020).
Is the flash_disc supposed to boot after the EvoX bios is "initiated" (like a game or any other disc)?
BIG thanx ;D
|
|
|
|
Post by Mechaman on Dec 4, 2004 1:01:26 GMT 8
Just in case your modchip is using the "a" version of the SST add in the following line in raincoat.cfg flash = 0xbf52,"SST SST49LF020A",0x40000; Yes, the 1st disk boots up just like any other disk. Remember to follow the instructions and wait for the tray to eject before putting in the 2nd disk. no problems, glad to be of service ;D The xbox is a v1.4, but thanx for the notice.. I'm just wondering, do i need to include the raincoat.cfg when flashing this chip? (It's a SST49LF020). Is the flash_disc supposed to boot after the EvoX bios is "initiated" (like a game or any other disc)? BIG thanx ;D |
|
and no success trying to flash either.. It just boots into the preflashed bios (vanilla EvoX). Is there a way to force it into flashmode?
